The freezer is the main appliance you keep your home clean.
It’s usually in its most stable state when it’s in a closed fridge, but that doesn’t mean it’s the most reliable one to have in the home.
You’ll want to be able to fix your fridge when it breaks, or even when it starts to get dirty, and the most important part is that it’s clean.
There are two ways to fix a freezer.
The first is to repair it yourself, and then use an electric motor to open the freezer door.
This will cause the freezer to lock and you’ll need to open it to get in.
The second way to fix the freezer is to purchase a repair kit and get it installed in your fridge.
Here’s what you need.
How to fix freezer door and freezer door sealWhat you need:Tools:Drill a small hole to insert a small drill bit into a hole in the fridge door, then drill a small slot in the door for the motor to sit in.
Cut a piece of duct tape to fit the drill bit inside the hole in your door.
Place a piece (or two) of duct paper over the hole and secure with duct tape.
Attach the drill to the motor.
The first step is to drill a hole that’s small enough to fit a 3/8″ drill bit.
Drill at a depth of 1/8″, then remove the excess drill bit and drill the hole.
Use the same drill bit to make a small slit in the back of the freezer, then insert the hole into the hole, slide the motor up through the slit, and tighten it down.
The next step is easy.
Use a screwdriver to slide the plastic cap off the motor and onto the motor itself.
This is a very basic solution, but it’s not difficult.
If you don’t have the patience to do this yourself, there are several DIY repair kits on the internet.
Now you need a tool to slide a metal plate over the top of the motor, and install the motor into the back.
It should look like this:The motor will be mounted in the top right corner of the fridge.
Remove the cap from the motor using the screwdriver.
Now slide the top plate of the motors motor onto the hole on the back and install it into the freezer.
There should now be a gap between the motor’s motor housing and the back plate of your freezer.
Slide the motor over the plate, and use the screw drivers to secure the motor in place.
The next time you open your freezer door, the freezer should be completely sealed.
This may take a while, and if it does, your freezer is going to be very dirty.
But if you do have to open your door again, you should have no problems with it being completely sealed again.
More about refrigerators: